Packaging and Contents
The Hyper 212 comes in a plastic bubble pack
wrapped in a very stylish box.
The plastic bubble pack is very similar to the one
that Intel uses for its heat sinks.
Inside the plastic pack you will find everything you
need to install the Hyper 212 onto your CPU. All of the hardware you need is also
included. You'll find brackets, backing plates, screws, washers
and nuts. CoolerMaster even throws in some heat sink grease and
directions.
Layout
The
Hyper 212 has 4 heat pipes that extend through two aluminum sets of
fins. You can have up to two 120mm fans attached to the heat sink
to help cool.
The fan is a
120mm x 120mm x 25mm design that
rotates at 2200RPMs. Because of the relative low RPM speed the
noise is only 19dBA.
The base is a copper block where
the four heatpipes attach. It has a nice mirror finish, and
appears to be very flat.
